Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the.
Diy gutter planter.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
Garden answer youtube.
The front and back of each gutter piece will have 2 holes.
Tie a knot at one end of the 10 foot rope.
For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.
This will lock each segment along the suspension wire.
Start by drilling the bottom holes using your drill and 3 8inch bit.
Measure 12 inches of.